If you are in the room with the mixer then that is the control room.
Mixer control room vs main out.
There are 3 major solo modes you can encounter on a mixer.
Control room speakers are to be hooked up to the large and small 1 4 trs connectors.
Main mix outputs and aux output s are mixes that are sent to yo.
Use that to monitor the main out when you need to.
Pfl afl and sip pfl pre fader listening will route the selected signal to the monitors before fader pan and eq so you can hear the signal as it is when it comes into your mixer.
By doing it this way any changes to listening level are independent of desk settings.
1 2 original message date.
Don t worry about where the control room is.
Ok here goes the newbie guide to solo modes.
You may have to register before you can post.
I connect monitors and headphones via control room out not main out.
Both are fed on channel 7.
Ok octevio the main outs on a mixer console is your stereo output sockets the connectors are a 3 pin xlr on your larger console but it can also be a 6 5 mm trc jack sockets or rca.
Click the register link above to proceed.
Mixer mbox mini 2 control room and main out questions if this is your first visit be sure to check out the faq by clicking the link above.
Stereo out balanced xlr connections 1 ground 2 hot 3 cold which output the stereo buss signals which can be used to feed the analog inputs of a 2 track recorder or a specialist chain of analog devices used for mastering.
Then i tweaked the control room out volume knob on the behringer until it had the same overall gain as the soundcraft.
There is also a min mix switch that send the main mix output to the phones cntrl room output.
Just give it a go.
I take sound card out and feed that to the desk tape in which i route to the control room.
The behringer is recorded on the left control room output the soundcraft on aux 2.
All buttons were depressed except for the main to control room button on the behringer.